Xerox ii LINXSolid Inkjet 100 Service Manual page 167

sensor assembly's encoder wheel groove. This ensures that the
encoder wheel is not tensioned and slides easily onto the drum
shaft.
2. If not already mounted in place, secure the drum-position
sensor assembly onto the drum shaft and secure it to the
printer frame.
3. Through the access hole in the drum-position sensor assembly,
position the encoder gap tool on the drum shaft, maintaining a
position perpendicular to the shaft.
4. Reposition the drum-position sensor assembly's encoder wheel
on the drum shaft until it butts firmly against the encoder gap
tool.
5. Holding the gap tool in place, with a small, flatblade
screwdriver, slide the encoder wheel's retaining spring into the
encoder wheel's groove.
6. Remove the gap tool. Reassemble the printer and make a test
print.
Adjustments 4-23