Transfix Roller Pressure Spring Adjustment - Xerox ii LINXSolid Inkjet 100 Service Manual

4-24 ii LINX™ Solid Inkjet 100 Service Manual
Gap tool
Groove
Retaining
spring
Drum position
sensor
assembly
Figure 4-9. Setting The Drum Position Encoder Gap

Transfix Roller Pressure Spring Adjustment

1. Print the Service Test Print 16: Primary Solid Fills (4 pages).
2. If any of the prints are wrinkled on both the left and right sides
of the print, the drum/transfix assembly must be replaced. No
adjustment will solve the problem.
3. If wrinkling is only present on the left or right side of any
print, note which side.
4. Remove the front cover to access the drum/transfix assembly.
5. Draw a reference mark on the both the left and right spring set
screws.
0388-33