Chapter 10 Utility Commands; Overview Util Commands - NETGEAR ProSafe FVS318N Cli Reference Manual

Utility Commands
10.
This chapter explains the configuration commands, keywords, and associated parameters in the
Util mode. The chapter includes the following sections:
•

Overview Util Commands

• Firmware Backup, Restore, and Upgrade Commands
• Diagnostic Commands
Overview Util Commands
Enter the util ? command at the CLI prompt to display the description of the utility
commands in the util mode. The following table lists the commands in alphabetical order:
Table 19. Utility commands in the util mode
Command Name
util backup_configuration
util dns_lookup
util firmware_upgrade
util ping
util ping_through_vpn_tunnel
util reboot
util restore_factory_defaults
util routing_table_ipv4
util routing_table_ipv6
util traceroute
util upload_configuration
Purpose
Back up the configuration file of the wireless VPN firewall to a
TFTP server.
Look up the IP address of a domain name.
Upgrade the firmware of the wireless VPN firewall from a TFTP
server.
Ping an IP address.
Ping a VPN endpoint IP address.
Reboot the wireless VPN firewall.
Restore the wireless VPN firewall to factory default settings.
Display the IPv4 routing table.
Display the IPv6 routing table.
Trace a route to an IP address.
Upload a previously backed-up configuration file of the wireless
VPN firewall from a TFTP server
290
10