NETGEAR ProSafe FVS318N Cli Reference Manual page 189

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Keyword (might consist of two separate
words)
general_ip_version
general_remote_end_point_type
general_remote_end_point fqdn
general_remote_end_point ip_adress
Associated
Keyword to Select
or Parameter to
Type
IPv4 or IPv6
IP-Address or
FQDN
domain name
ipaddress
VPN Mode Configuration Commands
189
Description
If the general_remote_end_point_type
keyword is set to IP-Address, specifies the
IP address version for the remote endpoint,
local address information, and remote
address information:
• IPv4. The IPv4 selection requires you to
specify IPv4 addresses for the following
keywords:
-
general_remote_end_point
ipaddress
- general_local_start_address
- general_local_end_address
- general_remote_start_address
- general_remote_end_address
• IPv6. The IPv6 selection requires you to
specify IPv6 addresses for the following
keywords:
- general_remote_end_point
ipv6address
- general_local_start_address_ipv6
- general_local_end_address_ipv6
- general_remote_start_address_ipv6
- general_remote_end_address_ipv6
Specifies whether the remote endpoint is
defined by an IP address or a domain name:
• IP-Address. Depending on the setting of
the general_ip_version keyword, you
need to either issue the
general_remote_end_point
ip_address keyword and specify an IPv4
address or issue the
general_remote_end_point
ipv6_adress keyword and specify an
IPv6 address.
• FQDN. You need to issue the
general_remote_end_point fqdn
keyword and specify a domain name.
If the general_remote_end_point_type
keyword is set to FQDN, the domain name
(FQDN) of the remote endpoint.
If the general_remote_end_point_type
keyword is set to IP-Address, and if the
general_ip_version keyword is set to
IPv4, the IPv4 address of the remote
endpoint.