Chapter 2 Overview Of The Configuration Commands; Network Settings (Net Mode) Configuration Commands - NETGEAR ProSafe FVS318N Cli Reference Manual

Overview of the Configuration
2.
Commands
This chapter provides an overview of all configuration commands in the five configuration
command modes. The keywords and associated parameters that are available for these
commands are explained in the following chapters. The chapter includes the following sections:
•

Network Settings (Net Mode) Configuration Commands

• Security Settings (Security Mode) Configuration Commands
• Administrative and Monitoring Settings (System Mode) Configuration Commands
• Wireless Settings (Dot11 Mode) Configuration Commands
• VPN Settings (VPN Mode) Configuration Commands
Network Settings (Net Mode) Configuration Commands
Enter the net ? command at the CLI prompt to display the description of all the
configuration commands in the net mode. The following table lists the commands in
alphabetical order:
Table 7. Net mode configuration commands
Submode Command Name
ddns net ddns configure
net dmz ipv4 configure
net dmz ipv6 configure
dmz
net dmz ipv6 pool configure
ethernet net ethernet configure <interface name or number>
ipv6 net ipv6 ipmode configure
Purpose
Enable, configure, or disable Dynamic
DNS (DDNS) service.
Enable, configure, or disable the IPv4
DMZ.
Enable, configure, or disable the IPv6
DMZ.
Configure a new or existing IPv6 DMZ
DHCP address pool.
Configure a VLAN for a LAN interface.
Configure the IP mode (IPv4 only or
IPv4/IPv6).
18
2