NETGEAR ProSafe FVS318N Cli Reference Manual page 118

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Keyword (might consist of two
separate words)
destination_address_type
destination_start_address
destination_end_address
QoS profile and logging
qos_priority
log
Command example:
FVS318N> security firewall ipv6 configure
security-config[firewall-ipv6]> from_zone WAN
security-config[firewall-ipv6]> to_zone LAN
security-config[firewall-ipv6]> service_name default_services RTELNET
security-config[firewall-ipv6]> action ALWAYS_ALLOW
security-config[firewall-ipv6]> source_address_type SINGLE_ADDRESS
security-config[firewall-ipv6]> source_start_address 2002::B32:AAB1:fD41
security-config[firewall-ipv6]> destination_address_type SINGLE_ADDRESS
security-config[firewall-ipv6]> destination_start_address FEC0::db8:145
security-config[firewall-ipv6]> log ALWAYS
security-config[firewall-ipv6]> save
Related show command:
security firewall ipv6 edit <row id>
This command configures an existing IPv6 firewall rule. After you have issued the security
firewall ipv6 edit command to specify the row to be edited (for row information, see
Associated Keyword to Select or
Parameter to Type
ANY, SINGLE_ADDRESS, or
ADDRESS_RANGE
ipv6-address
ipv6-address
Normal-Service, Minimize-Cost,
Maximize-Reliability,
Maximize-Throughput, or
Minimize-Delay
NEVER or ALWAYS
show security firewall ipv6 setup
Security Mode Configuration Commands
118
Description
The type of destination address.
There are two options:
• The IPv6 address if the
destination_address_type
keyword is set to
SINGLE_ADDRESS.
• The start IPv6 address if the
destination_address_type
keyword is set to
ADDRESS_RANGE.
The end IPv6 address if the
destination_address_type
keyword is set to
ADDRESS_RANGE.
The type of QoS that applies to
the rule. You can apply QoS to
LAN WAN and DMZ WAN
outbound rules only.
Enables or disables logging.