Upnp Command - NETGEAR ProSafe FVS318N Cli Reference Manual

Keyword
name
enable_rule
protocol
outgoing_start_port number
outgoing_end_port
incoming_start_port number
incoming_end_port
Related show command:
porttriggering_rules status
security porttriggering_rules delete <row id>
This command deletes a port triggering rule by deleting its row.
Format
security porttriggering_rules delete <row id>
Mode security
Related show command:
porttriggering_rules status

UPnP Command

security upnp configure
This command configures Universal Plug and Play (UPnP). After you have issued the net
security upnp configure command, you enter the security-config [upnp] mode, and
then you can configure one keyword and associated parameter or associated keyword at a
time in the order that you prefer.
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Associated Keyword to
Select or Parameter to Type
rule name
Y or N
TCP or UDP
number
number
show security porttriggering_rules setup
show security porttriggering_rules setup
Security Mode Configuration Commands
Description
The name (alphanumeric string) of the port
triggering rule.
Enables or disables the port triggering rule.
Specifies whether the port uses the TCP or UDP
protocol.
The start port number (integer) of the outgoing
traffic range. Valid numbers are from 0 to 65535.
The end port number (integer) of the outgoing traffic
range. Valid numbers are from 0 to 65535.
The start port number (integer) of the incoming
traffic range. Valid numbers are from 0 to 65535.
The end port number (integer) of the incoming traffic
range. Valid numbers are from 0 to 65535.
and
and
134
show security
show security