Chapter 8 Overview Of The Show Commands; Network Settings (Net Mode) Show Commands - NETGEAR ProSafe FVS318N Cli Reference Manual

Overview of the Show Commands
8.
This chapter provides an overview of all show commands for the five configuration command
modes. The chapter includes the following sections:
•

Network Settings (Net Mode) Show Commands

• Security Settings (Security Mode) Show Commands
• Administrative and Monitoring Settings (System Mode) Show Commands
• Wireless Settings (Dot11 Mode) Show Commands
• VPN Settings (VPN Mode) Show Commands
Network Settings (Net Mode) Show Commands
Enter the show net ? command at the CLI prompt to display the categories of show
commands in the net mode. The following table lists the commands in alphabetical order:
Table 14. Show commands: show net mode
Submode Command Name
ddns show net ddns setup
dmz show net dmz ipv4 setup
show net dmz ipv6 setup
ethernet show net ethernet {interface name | all}
ipv6 show net ipv6 ipmode setup
show net ipv6_tunnel setup
ipv6_tunnel
show net ipv6_tunnel status
show net lan available_lan_hosts list
show net lan dhcp leased_clients list
lan
show net lan dhcp logs
Purpose
Display the Dynamic DNS configuration.
Display the IPv4 DMZ configuration.
Display the IPv6 DMZ configuration.
Display the MAC address and VLAN status for a
single or all Ethernet interfaces.
Display the IPv6 routing mode configuration.
Display the IPv6 tunnel configuration.
Display the status of the IPv6 tunnels.
Display the IPv4 hosts.
Display the LAN clients that received a leased
DHCP IP address.
Display the LAN DHCP log.
239
8