Chapter 5 System Mode Configuration Commands; Remote Management Commands - NETGEAR ProSafe FVS318N Cli Reference Manual

System Mode Configuration Commands
5.
This chapter explains the configuration commands, keywords, and associated parameters in the
system mode. The chapter includes the following sections:
•

Remote Management Commands

• SNMP Commands
• Time Zone Command
• Traffic Meter Command
• Firewall Logs and Email Alerts Commands
IMPORTANT:
After you have issued a command that includes the word
configure, add, or edit, you need to save (or cancel) your
changes. For more information, see
Remote Management Commands
system remote_management https configure
This command configures remote management over HTTPS. After you have issued the
system remote_management https configure command, you enter the
system-config [https] mode, and then you can configure one keyword and associated
parameter or associated keyword at a time in the order that you prefer.
Note: You can configure remote management over HTTPS for both IPv4
and IPv6 connections because these connections are not mutually
exclusive.
Step 1 Format
Mode
system remote_management https configure
system
Save Commands
144
5
on page 13.