NETGEAR ProSafe FVS318N Cli Reference Manual page 145

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Step 2 Format
ip_version {IPv4 | IPv6}
enable_ipv4 {Y | N}
access_type {Everyone | IP_Range {from_address <ipaddress>}
port <number>
enable_ipv6 {Y | N}
access_type6 {Everyone | IP_Range {from_address6
port <number>
Mode system-config [https]
Keyword Associated Keyword to
Select or Parameter to Type
IPv4 or IPv6
ip_version
HTTPS over an IPv4 connection
Y or N
enable_ipv4
Everyone, IP_Range, or
access_type
To_this_PC_only
from_address ipaddress
end_address ipaddress
only_this_pc_ip ipaddress
port number
HTTPS over an IPv6 connection
Y or N
enable_ipv6
{end_address <ipaddress>} | To_this_PC_only {only_this_pc_ip
<ipaddress>}}
<ipv6-address>} {end_address6 <ipv6-address>} |
To_this_PC_only {only_this_pc_ipv6 <ipv6-address>}}
System Mode Configuration Commands
145
Description
Specifies the configuration of IPv4 or IPv6.
Enables or disables remote management over
HTTPS for an IPv4 connection.
Specifies the type of access:
• Everyone. Enables access to all IP addresses.
You do not need to configure any IP address.
• IP_Range. Enables access to a range of IP
addresses. You also need to configure the
from_address and end_address keywords and
associated parameters.
• To_this_PC_only. Enables access to a single IP
address. You also need to configure the
only_this_pc_ip keyword and associated
parameter.
The start IP address if you have set the
access_type keyword to IP_Range.
The end IP address if you have set the
access_type keyword to IP_Range.
The single IP address if you have set the
access_type keyword to To_this_PC_only.
The number of the port through which access is
allowed.
Enables or disables remote management over
HTTPS for an IPv6 connection.