NETGEAR ProSafe FVS318N Cli Reference Manual page 230

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Keyword
ip_version
policy_address
policy_mask_length
policy_address6
policy_ipv6_prefix_length
start_port
end_port
service_type
Command example:
FVS318N> vpn sslvpn policy add
[sslvpn-policy-settings]> policy_name RemoteWorkers
[sslvpn-policy-settings]> ip_version IPv4
Associated Keyword to
Select or Parameter to Type
IPv4 or IPv6
ipaddress
subnet mask
ipv6-address
prefix length
port number
port number
VPNTunnel,
PortForwarding, or All
VPN Mode Configuration Commands
230
Description
The IP version that applies to the policy:
• IPv4. The policy is for an IPv4 network
resource, IPv4 address, IPv4 network, or for
all IPv4 addresses.
For an IP address or IP network, you need to
issue the policy_address keyword and
specify an IPv4 address. For a network
address, you also need to issue the
policy_mask_length keyword and specify
a subnet mask.
• IPv6. The policy is for an IPv6 network
resource, IPv6 address, IPv6 network, or for
all IPv6 addresses.
For an IP address or IP network, you need to
issue the policy_address6 keyword and
specify an IPv6 address. For a network
address, you also need to issue the
policy_ipv6_prefix_length keyword
and specify a prefix length.
The IPv4 address, if the policy is for an IPv4
address or IPv4 network.
The subnet mask, if the policy is for an IPv4
network.
The IPv6 address, if the policy is for an IPv6
address or IPv6 network.
The prefix length, if the policy is for an IPv6
network.
The start port number for a policy port range.
(This does not apply if the policy is for a
network resource.)
The end port number for a policy port range.
(This does not apply if the policy is for a
network resource.)
The service type for the policy:
• VPNTunnel. The policy is applied only to a
VPN tunnel.
• PortForwarding. The policy is applied only to
port forwarding.
• All. The policy is applied both to a VPN
tunnel and to port forwarding.