NETGEAR ProSafe FVS318N Cli Reference Manual page 191

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Keyword (might consist of two separate
words)
general_keep_alive_failue_count
Traffic selector settings—Local address information
general_local_network_type
general_local_start_address
Associated
Keyword to Select
or Parameter to
Type
number
ANY, SINGLE,
RANGE, or SUBNET
ipaddress
VPN Mode Configuration Commands
191
Description
The maximum number of keep-alive request
failures before the wireless VPN firewall
tears down the connection and then attempts
to reconnect to the peer.
Specifies the address or addresses that are
part of the VPN tunnel on the wireless VPN
firewall:
• ANY. All computers and devices on the
network.
• SINGLE. A single IP address on the
network. Depending on the setting of the
general_ip_version keyword, issue
one of the following keywords:
- general_local_start_address to
specify an IPv4 address.
-
general_local_start_address_ipv6
to specify an IPv6 address.
• RANGE. A range of IP addresses on the
network. Depending on the setting of the
general_ip_version keyword, issue
one of the following sets of keywords:
- general_local_start_address
and general_local_end_address
to specify IPv4 addresses.
-
general_local_start_address_ipv6
and
general_local_end_address_ipv6
specify IPv6 addresses.
• SUBNET. A subnet on the network.
Depending on the setting of the
general_ip_version keyword, issue
one of the following sets of keywords:
- general_local_start_address to
specify an IPv4 address and
general_local_subnet_mask to
specify a subnet mask.
-
general_local_start_address_ipv6
to specify an IPv6 address and
general_local_ipv6_prefix_length
to specify a prefix length.
If the general_local_network_type keyword is
set to SINGLE, RANGE, or SUBNET, and if the
general_ip_version keyword is set to
IPv4, specifies the local IPv4 (start)
address.
to