Segmented Lan Deployment; Use The Installation Guide To Perform Initial Configuration - NETGEAR STM150 Reference Manual

ProSecure Web/Email Threat Manager STM150 Reference Manual

Segmented LAN Deployment

.
Figure 2-3
In a segmented LAN deployment, one the STM150 appliance is installed in front of each network
segment. This type of deployment helps split the network load and protects network segments
from malware coming in through the gateway or originating from other segments.
Note: In segmented LAN deployment, VLAN is not supported; VLAN traffic cannot pass
through the STM150.

Use the Installation Guide to Perform Initial Configuration

Use the installation guide to perform the initial configuration of the STM150's basic system
settings (for example, IP address, netmask, and DNS) so that it can function on the network. To
perform the initial configuration, follow the instructions in the NETGEAR Installation Guide,
STM150. The installation guide will walk you through connecting the unit, and using the setup
wizard to complete the initial configuration. After using the setup wizard to complete the initial
configuration, you can log in to make additional changes or to monitor the system using the steps
below.
2-4 Provisioning Threat Management Services
v1.0, January 2009