Lct Size Setting; Data Capture - Konica Minolta Magicolor 8650 Service Manual

10. Service Mode
10.3.8

LCT Size Setting

Functions • To set the paper size for the LCT.
Use • Use to change the paper size for the LCT (PC-406).
Setting/ • The default setting depends on the setting made for the applicable marketing area.
Procedure
10.3.9

Data Capture

Functions • When an error occurs, it acquires the print job data in order to analyze the cause of
the error.
Use • When an error occurs, this will be used to analyze the cause of the error according to
the print job data.
Setting/ • The default setting is "OFF."
Procedure
NOTE
• The following conditions are necessary for this function.
When selecting [Security Settings] → [Security Details] → [PrintDataCapture]
in Admin. Settings, [Allow] must be set.
The hard disk must be mounted to the machine.
1. Select [Service Mode] → [System Settings] → [Data Capture]. Select [ON].
(While the Data Capture setting is [ON], the print job data from the PC will be stored
in the hard disk.)
NOTE
• The original offset value can be disabled to address image failure and other
problems caused by individual CCD performance difference.
2. Check the IP address of the machine.
3. Connect the PC (Windows) and the machine with ethernet cable.
4. Start the DOS command prompt of the PC, and specify the IP address of the
machine to start FTP.
212
Confidential – for internal use only, do not distribute
A4
ON
Field Service Ver. 2.0 Nov. 2007
Letter
"OFF"
4037F3E538DA