Mitsubishi 00JCPU User Manual page 375

8.4 Remote Password
This section provides the list of parameters for use of remote password and describes parameter details.
A remote password is set for an Ethernet module, serial communication module, or modem interface module.
Parameter
Item
No.
Password settings -
Model
-
name
Password
active
module
settings
Start XY -
Detail -
User connection No. -
System connection -
Figure 8.30 Remote password settings dialog box
Table8.33 Remote password setting list
Description
Enter a remote password.
Select a model name of the module
for which the remote password set to
the CPU module is checked.
Set the start address of the module
for which the remote password is
checked.
Set details of the remote password for
the QJ71E71.
Select user connection No.
Select a valid port of the remote
password for system connection.
Setting range
Four characters or less
(alphanumeric characters, special
symbols)
QJ71E71
QJ71C24/CMO
• Basic model QCPU:
0000 to 03E0
H H
• High Performance model QCPU,
Process CPU, and Redundant
CPU: 0000 to 0FE0
H H
-
Connection 1 to Connection 16
Specify a valid port of the remote
password.
Auto open UDP port
FTP transmission port (TCP/IP)
GX Developer transmission port
(TCP/IP)
GX Developer transmission port
(UDP/IP), Dedicated instruction,
CC IE Control, MNET/10(H) relay
transmission port.
HTTP port
CHAPTER8 PARAMETERS
Default Reference
-
-
-
• QJ71E71:
Ethernet module
manual
• QJ71C24: Serial
-
communication
module manual
-
• QJ71CMO:
Modem interface
module manual
-
8 - 34
1
2
3
4
5
6
7
8