Mitsubishi 00JCPU User Manual page 519

CHAPTER11 PROCEDURES FOR WRITING PROGRAM TO CPU MODULE
1)
NO
Set local devices?
YES
Set the local device range in the Device
tab of the PLC parameter dialog box.
Set a file name for the local devices in the
PLC file tab of the PLC parameter dialog box.
NO
Use the common pointers?
YES
Set the start pointer number in the PLC
system tab of the PLC parameter dialog box.
Set the names and execution conditions
of programs to be executed in the
Program tab of the PLC parameter dialog box.
Set the parameter-valid drive
with the DIP switches (SW2, SW3).
Connect the personal computer to which GX
Developer is installed to the CPU module.
Set the RUN/STOP switch to STOP,
turn the RESET/L.CLR switch to reset clear
position, and power on the CPU module
(the ERR. LED turns on).
Select [Online] [Format PLC memory]
in GX Developer and format
the program memory.
Select [Online] [Write to PLC]
"Program memory/Device memory" for
"Target memory" in GX Developer and
write the parameters and created programs.
2)
Section 9.13.2
Section 9.13.2
Section 9.9
Section 2.3
*1
*2
*3
Write to PLC screen
*4
1
2
11
4
5
6
7
8
11 - 13