Mitsubishi 00JCPU User Manual page 266

3) When selecting "Memory card (RAM)" in "Target memory" while the SRAM card where the sampling trace
file has been registered is not mounted, either of the following operations were performed.
• The CPU module is powered off and then on.
• The CPU module is reset.
4) When selecting "Memory card (RAM)" in "Target memory" and the sampling trace file is corrupt, either of the
following operations were performed.
• The CPU module is powered off and then on.
• The CPU module is reset.
(c) Reading trace result in the STOP status
The trace result cannot be read while the CPU module is in the STOP status.
When reading the trace result, read it while the CPU module is in the RUN status.
(d) Sampling trace registration while the trigger condition is established
When registering the sampling trace setting, the trigger condition set for the trigger point must not to be
established.
If the condition is established, the setting cannot be registered.
(e) When a file register is selected as a specified device by the detail setting of trace
conditions
When a file register is selected as a specified device by the detail setting of trace point setting and trigger point
setting, do not change the block numbers of file register file and file register after trace registration.
Trace data may not be normally sampled.
(f) Trace point setting
When setting the trace point setting per each time, pay attention to the sampling interval and sampling
processing time for one sampling since the sampling trace is performed as interrupt processing.
If the sampling processing time for one sampling is long, "WDT ERROR" may be detected.
(g) Performing sampling trace during execution of another sampling trace
The first sampling trace is performed normally.
The second sampling trace cannot be performed.
(h) Executing online change
When sampling trace and online change are performed simultaneously, they operate as follows.
1) Performing sampling trace during online change
• The trace point or trigger point is specified by the step number:
The online change is completed normally but the sampling trace is not performed.
• The trace point and trigger point are specified by except the step number:
Both the online change and sampling trace can be performed.
2) Performing online change during execution of sampling trace
• The trace point or trigger point is specified by the step number:
The sampling trace is suspended but the online change is normally performed.
• The trace point and trigger point are specified by except the step number:
Both the online change and sampling trace can be performed.
6 - 86