Mitsubishi 00JCPU User Manual page 345

Parameter
Item
Points occupied by empty slot
Interrupt counter
start No.
System
interrupt
Fixed scan
settings
interval
(n: 28 to 31)
Interrupt program/Fixed scan
*1
program setting
*1: The Basic model QCPU does not support the use of fixed scan execution type programs.
(3) PLC file
Parameters required for the files used in the CPU module are set.
Parameter
Item
No.
Initial Device value 1102
Table8.2 PLC system setting list (continued)
Description
No.
Set the number of points for
1007 empty slots on the main/extension
H
base units.
Set the start number of interrupt
counters.
1008
H
Set each execution interval for the
interrupt pointers (I28 to I31).
Enable or disable high speed
1008
H
execution of interrupt programs.
Figure 8.3 PLC file
Table8.3 PLC file setting list
Description
Set a file for initial values of the
H
devices used for the CPU module.
Setting range
[Q00JCPU]
0, 16, 32, 64, 128, or 256 points
[Q00CPU and Q01CPU]
0, 16, 32, 64, 128, 256, 512, or
1024 points
C0 to C13184 (Up to "The
number of counter setting points -
128")
2ms to 1000ms (in increments of
1ms)
Selected/deselected
Setting range
Not used/Use Not used
CHAPTER8 PARAMETERS
Default Reference
16 points Section 4.2.2
Section
Blank
9.2.11(4)
• I28: 100ms
• I29: 40ms
Section 9.10
• I30: 20ms
• I31: 10ms
Deselected Section 2.2.3
Default Reference
Section 6.26
8 - 4
1
2
3
4
5
6
7
8