Mitsubishi 00JCPU User Manual page 351

Parameter
Item
No.
Base model
name
Power model
name
Base
0401
H
setting
Extension
cable
Slots
Switch setting 0407
H
Error time
0403
H
output mode
H/W error
time PLC
4004
H
operation
mode
Detailed
setting
I/O response
0405
H
time
Control PLC 0406
H
Table8.8 I/O assignment setting list (continued)
Description
Set the model name of the main
base unit or extension base
unit. (Entered at user's Up to 16 characters
discretion. Do not use the one
for the CPU module.)
Set the model name of the
power supply module on the
main base unit or extension
Up to 16 characters
base unit. (Entered at user's
discretion. Do not use the one
for the CPU module.)
Set the extension cable name.
(Entered at user's discretion.
Up to 16 characters
Do not use the one for the CPU
module.)
Set the number of slots of the
main base unit or extension
base unit. 2, 3, 5, 8, 10, or 12
This setting must be done for all
base units.
Set various switches of an Refer to the manual for the
intelligent function module. intelligent function module used.
Set whether to clear or hold the
output in case of a stop error in Clear/Hold
the control CPU.
Set whether to stop or continue
the operation of the control
CPU in case of a hardware Stop/Continue
failure of the intelligent function
module.
Set a response time for the • Input or I/O mix: 1ms, 5ms,
input module, high-speed input
module, I/O combined module, • Hi input or Interrupt: 0.1ms,
or interrupt module.
Set the control CPU for the input/
output modules and intelligent No.1, No.2, No.3, or No.4
function module.
Setting range
Blank
Blank
Clear
Stop
• Input or I/O mix:
10ms, 20ms, or 70ms 10ms
• Hi input or Interrupt:
0.2ms, 0.4ms, 0.6ms, or 1ms 0.2ms
No.1
CHAPTER8 PARAMETERS
Default Reference
Section 4.1.2
Section 6.10
Section 6.8
Section 6.9
Section 6.7
QCPU User's
Manual (Multiple
CPU System)
8 - 10
1
2
3
4
5
6
7
8