Mitsubishi 00JCPU User Manual page 325

(3) Timing when initial device values are written to the specified device
The CPU module writes data in the specified initial device value file to the specified device or the buffer memory
of the intelligent function module when the CPU module is powered off and then on, is reset, or is set to the STOP
status and then the RUN status.
Setting of
initial device
value range
Setting of
GX Developer
initial device
value range
(4) Devices that can be used
The following shows devices that can be used for initial device value.
• Current timer value (T)
• Current retentive timer value (ST)
• Current counter value (C)
• Data register (D)
• Special register (SD)
• Link register (W)
Program memory
Writing of initial
device value
Figure 6.97 Flow of writing initial device value
*1
• Link special register (SW)
• File register (R)
• File register (ZR)
• Intelligent function module device (U \G )
• Link direct device (J \W , J \SW )
*1: For available ranges, refer to Section 9.1.
Initial
device
(At power-off on, reset,
value file
or STOP RUN)
Writing of initial device value
(at power off
STOP RUN)
CHAPTER6 FUNCTIONS
Specified
device
on, reset, or
6 - 145
1
2
3
4
5
6
7
8