Mitsubishi 00JCPU User Manual page 296

(1) Installed status
The following information of the module mounted on the selected base unit can be checked.
• Control CPU (except the Basic model QCPU)
• Model name
• Number of points
"Unmounting" is displayed in the field of a number of slot where a module is not mounted.
When using a redundant base unit, mounted status of the power supply module is also displayed (not displayed
for the Basic model QCPU).
*1: The model name of a module on a slot to which "Empty" is set in the I/O assignment tab of the PLC parameter dialog box
is not displayed.
(2) Parameter status
The following information on the module on each slot of the selected base unit can be displayed.
• I/O number
• Module type
• Number of points
If setting configured in the I/O assignment tab of the PLC parameter dialog box and the mounted status differ,
"None 0 pt" or an assignment error is displayed.
Therefore, change the I/O assignment setting so that it may match with the mounted status.
When using a redundant base unit, operating status of the power supply module is also displayed. (not displayed
for the Basic model QCPU).
(3) Base
The status of the base unit and modules on the base unit can be checked.
When there is even one faulty module, the "Module" field color changes according to the status described at the
bottom of the screen.
(4) Mode
Note6.25
Use this option for online module change.
For online module change, refer to the following.
QCPU User's Manual (Hardware Design, Maintenance and Inspection)
Manual for the module supporting the online module change
(5) Diagnostics
Click this button to check an error and status of the selected module.
Note25
Note6.25
Basic
Since the Basic model QCPU and High Performance model QCPU cannot be changed online, "Mode" cannot be
6 - 116
*1
Note25
High
performance