Mitsubishi 00JCPU User Manual page 511

1)
Select [Online] [Format PLC memory]
in GX Developer and format the
program memory or standard ROM.
To write the parameters, created program,
and initial device value, make settings
in the Write to PLC screen displayed by selecting
[Online] [Write to PLC] in GX Developer.
Power off the programmable controller
and then on or reset the CPU module.
Set the RUN/STOP/RESET switch to RUN
to change the CPU module in the RUN status.
NO
Is the ERR. LED
on the CPU module on
(flashing)?
Check the error cause in the System Monitor
screen displayed by selecting [Diagnostics]
[System Monitor] in GX Developer or in the
"PLC diagnostics" screen and remove the error.
NO
Start boot operation?
To Section 11.1.3
End
Figure 11.2 Flowchart for writing a program
CHAPTER11 PROCEDURES FOR WRITING PROGRAM TO CPU MODULE
QCPU User's Manual
(Hardware Design, Maintenance and Inspection)
YES
YES
Write to PLC screen
QCPU User's Manual
(Hardware Design, Maintenance and Inspection)
1
2
11
4
5
6
7
8
11 - 5