Mitsubishi 00JCPU User Manual page 356

(2) PLC system
Parameters required for use of the CPU module are set.
Parameter
Item
No.
Low
Timer
speed
limit 1000
High
setting
speed
RUN
RUN-
PAUSE 1001
contcts
PAUSE
Remote reset 1002
Output mode at STOP
1003
to RUN
Intelligent function
module setting
100A
(Interrupt pointer
setting)
Module
100C
synchronization
Common pointer No. 1005
Points occupied by
1007
empty slot
Fixed
System scan
interrupt interval 1008
settings (n: 28 to
31)
Interrupt program/
Fixed scan program 1008
setting
8 - 15
Figure 8.13 PLC system
Table8.13 PLC system setting list
Description
Set the time limit for the low speed timer
H
or high speed timer.
Set the contacts that control RUN/
PAUSE of the CPU module. Setting of
H
only the PAUSE contact is not allowed.
Select whether to allow the remote reset
H
from GX Developer.
Set the status of the outputs (Y) when
the operating status is switched from
H
STOP to RUN.
Assign the interrupt pointers (I50 to
I255) and set the start I/O number and
H
start SI number of each intelligent
function module.
Select whether to synchronize CPU
module startup with intelligent function
H
module startup.
Set the start number of common
H
pointers.
Set the number of points for empty slots
H
on the main/extension base units.
Set each execution interval for the
H
interrupt pointers (I28 to I31).
Enable or disable high speed execution
of interrupt programs or fixed scan
H
execution type programs.
Setting range
1ms to 1000ms (in increments of 1ms)
0.01ms to 100.0ms (in increments of
0.01ms)
X0 to X1FFF
Selected/deselected
Previous state, Recalculate (output is 1
scan later)
• Start I/O No.
• Start SI No.
• I50 to I255
Selected/deselected
P0 to P4095
0, 16, 32, 64, 128, 256, 512, or 1024
points
0.5ms to 1000ms
(in increments of 0.5ms)
Selected/deselected
Default Reference
Section
100ms
9.2.10
Section
10.0ms
9.2.10
Section
6.6.1
Blank
Section
6.6.2
Section
Deselected
6.6.3
Previous state Section 6.4
Blank Section 6.23
Deselected -
Section
Blank
9.9.2
Section
16 points
4.2.2
• I28: 100.0ms
• I29: 40.0ms
Section 9.10
• I30: 20.0ms
• I31: 10.0ms
Section
2.2.3,
Deselected
Section
2.3.5