Mitsubishi 00JCPU User Manual page 466

(3) Process CPU
Table9.17 List of interrupt pointer numbers and interrupt factors (Process CPU)
I No. Interrupt factor
I0
I1
I2
I3
I4
I5
I6
I7
Interrupt by interrupt
I8 module (QI60)
I9
I10
I11
I12
I13
I14
I15
I16 to
I27
I28
Interrupt by
I29
*1
I30
internal timer
I31
*1: The time-limit value of the internal timer is set by default.
In the PLC system tab of the PLC parameter dialog box, the value can be changed within the range of 0.5ms to 1000ms in increments of
0.5ms.
*2: This is applicable to the module whose serial number (first five digits) is "07032" or later.
*3: In the case of a multiple CPU system, this is applicable only to CPU No.1 when serial numbers (first five digits) of all CPU modules are
"07032" or later.
*4: After processing for "I32 (all of stop errors)" is completed, the Process CPU stops.
*5: Execution of I32 to I48 will be disabled (DI) if the system is powered on or when the Process CPU is reset.
To use any of I32 to I48, enable the interrupt with the IMASK instruction.
For the IMASK instruction, refer to the following.
MELSEC-Q/L Programming Manual (Common Instruction)
*6: To use the intelligent function module interrupt, the intelligent function module setting (interrupt pointer setting) is required in the PLC
system tab of the PLC parameter dialog box. (For interrupt from an intelligent function module, refer to Section 6.23.)
*7: I50 has the highest priority (priority 2), and I255 has the lowest priority (priority 207).
9 - 91
Priority
1st point 208
2nd point 209
3rd point 210
4th point 211
5th point 212
6th point 213
7th point 214
8th point 215
9th point 216
10th point 217
11th point 218
12th point 219
13th point 220
14th point 221
15th point 222
16th point 223
Empty
100ms 227
40ms 226
20ms 225
10ms 224
I No. Interrupt factor
*4
I32
I33
I34
I35 Interrupt by an
*4 *5
error
I36
I37
I38
I39
I40 to
49
Intelligent
I50 to
function module
255
interrupt
*6 *7
Priority
All of stop errors
SINGLE PS. DOWN
*2 *3
UNIT VERIFY ERR.,
FUSE BREAK OFF,
SP. UNIT ERROR,
MULTI CPU ERROR
OPERATION ERROR,
SFCP OPE. ERROR,
SFCP EXE. ERROR,
EX.POWER OFF
ICM. OPE ERROR,
FILE OPE. ERROR
Empty
PRG. TIME OVER
CHK instruction
execution, annunciator
detection
Empty
Specify the intelligent
function module or
2 to 207
interrupt module (QI60)
with a parameter.
1