Table of Contents
Advertisement
Connect your WAN access (for example DSL modem or cable modem) to the first
Ethernet port (BU201).
4.
Network
•
Connect further PCs to the 4 Ethernet ports BU202 (A - D). This switch
works independent of the telephone system. For direct connection to an-
other switch or hub no special connection cable is required. The transmis-
sion and reception lines of the Ethernet port will automatically be set cor-
rectly (auto negotiation).
5.
Close the wiring compartment cover.
6.
Connect your telephone system to the mains wall outlet.
7.
Program the relevant phone numbers (MSNs) within the ISDN telephones.
•
basic setting S
•
basic setting S
•
basic setting S
8.
First test:
•
Extension test:
Pick up the receiver of the telephone connected to S
ling tone.
Dial the 1. analogue port (pre-set phone number "50"). => The telephone
rings.
•
LAN test:
Switch the PCs on, which are connected to your telephone system.
=> The LED indicating the physical connection of the corresponding
Ethernet
port lights up (see "Status LEDs).
9.
Start the configuration. Configuration is performed by using a PC with a web
browser.
Access is available via the following ports:
•
via a LAN connection (recommended)
•
via the RS 232 port by accessing the dial-up network via a standard modem
with the setting "115200,8,n,1 without hardware flow control"
•
via the internal or external S
Internet access protocol
•
via the Internet by using the IP address of your DSL connection (IP address
assigned to you by your ISP)
Mounting
port 2:
0
port 3:
0
port 4:
0
ports by accessing the dial-up network via an
0
18
20 and 21
30 and 31
40 and 41
0
4. => You hear a dial-
Advertisement
Table of Contents
