Test Pattern Printing; Printing Test Pattern: Sp2109 002; Test Pattern Table - Ricoh B132 Service Manual

5.3 TEST PATTERN PRINTING

5.3.1 PRINTING TEST PATTERN: SP2109 002

Some of these test patterns are used for copy image adjustments but most are
used primarily for design testing. These test patterns do not use the IPU.
NOTE: Do not operate the machine until the test pattern is printed out completely.
Otherwise, an SC may occur.
1. Enter the SP mode and select SP2109 002
2. Enter the number for the test pattern that you want to print and press [#].
3. When you are prompted to confirm your selection, touch "Yes" to select the test
pattern for printing.
4. Touch "Copy Window" to open the copy window, then select the settings for the
test print (paper size, etc.)
5. Press the [Start] () key twice (ignore the "Place Original" messages) to start
the test print.
6. After checking the test pattern, press SP Mode (highlighted) to return to the SP
mode display.
7. Touch "Exit" twice to exit the SP mode.

Test Pattern Table

These patterns can be selected with SP2109 002.
0 Off
1 1-Dot Line
2 1-Dot Slant Cross-Stripe
3 2-Dot Horizontal Line
4 2-Dot Vertical Line
5 1-Dot Horizontal Line
6 1-Dot Vertical Line
7 1-Dot Independent
8 2-Dot Independent
9 4-Dot Independent
10 Trim Area
11 Belt Pattern
12 100% Coverage
13 Vertical Cross-Stitch
SM
14 Horizontal Cross-Stitch
15 Crop Marks
16 Vertical Belt
17 Checkered Flag
18 1-Dot 20 mm Grid
19 1-Dot 20 mm Slant Grid
20 Horizontal Grayscale
21 Horizontal Grayscale-White Stripes
5-9
TEST PATTERN PRINTING
B132/B200