Ricoh B132 Service Manual page 254

PCU
[A]
[E]
16. At the rear of the development unit, attach the lock gear [A] to the development
roller shaft.
17. At the front, attach the special tool [B].
Important
• The D-shaped hole of the special tool [C] must fit over the D-shaped shaft tip
[D].
18. If the hole of the special tool and shaft are not aligned, rotate the D-shaped
shaft tip [D] in the direction of the arrow to position the shaft so the special tool
can be attached.
Important
• Always rotate the shaft in the direction of the arrow [E]. To avoid damaging
the entrance seal, never rotate the lock gear in the opposite direction.
B132/B200
B132R219.WMF
3-44
[D]
[C]
[B]
SM