COPIER B132/B200
[C]
Reassemble the PCU
19. Reattach the development unit to the PCU.
IMPORTANT!
• H
ANDLE THE DEVELOPMENT UNIT CAREFULLY WHEN YOU REATTACH IT TO THE
AVOID DAMAGING THE DRUM INSIDE THE
20. Attach the front and rear lock plates (refer to p. 1-16).
21. Attach the shaft cap [A].
If you cannot attach the cap, then check the end of the development roller shaft
[B]. The flat side of the shaft must point up and must be level.
IMPORTANT!
• When you turn the shaft:
a) Use your fingers to turn the front and rear ends of the development roller
shaft until the end of the shaft is as shown [C].
b) Make sure that you hold the shaft and not the sleeve (the sleeve does not
turn).
c) To prevent damage to the shaft, do not hold the end of the shaft with
pliers.
B132/B200
[B]
PCU.
1-20
[A]
B132R222.WMF
PCU
TO
SM