Ricoh B132 Service Manual page 438

SERVICE CALL CONDITIONS
SC336 D Developer set error 1: K
SC337 D Developer set error 2: M
SC338 D Developer set error 3: C
SC339 D Developer set error 4: Y
The value of Vcnt is set at the
maximum or minimum setting
when the TD sensor is
initialized.
Open the front door.
Pull out the film seal from the black, magenta, cyan, or yellow developer case.
Be sure to do the correct SP for the affected color:
• SP3801 003 to initialize the TD sensor for black.
• SP3801 004 to initialize the TD sensor for magenta.
• SP3801 005 to initialize the TD sensor for cyan.
• SP3801 006 to initialize the TD sensor for yellow.
Toner cartridge set error 1: K
SC340 D
SC341 D Toner cartridge set error 2: M
SC342 D Toner cartridge set error 3: C
SC343 D Toner cartridge set error 4: Y
The machine cannot read the ID
chip of the black, magenta,
cyan, or yellow toner cartridge.
1. Open the front door.
2. Press down the release lever on the top edge of the toner bin to of the affect
3. Remove the toner cartridge and set it again.
SC348 D Toner supply motor error
2 sec. after the motor START signal is
output, a LOCK signal cannot be detected.
B132/B200
toner cartridge to release it, then pull the bin out to open it.
• Film seal not removed from the black,
magenta, cyan, or yellow developer case
• Black, magenta, cyan, or yellow toner
cartridge set incorrectly
• Motor harness disconnected,
loose, or defective
• Powder pump overload
• Sub hopper overload
• Toner hopper motor
defective
4-38 SM