Ricoh B132 Service Manual page 286

IMAGE TRANSFER UNIT
[A]
[E]
[A]: Encoder sensor bracket ( x1)
[B]: Set the image transfer unit on its front side up.
[C]: ID sensor/MUSIC sensor plate ( x2,  x1)
[D]: ITB
Important
• When you install the new belt, the
edge of the belt with the encoder film
strip must be at [E]. The encoder
must be at the rear side.
• The encoder edge of the ITB is silver.
• Be sure to reattach the ID
sensor/MUSIC sensor plate [C]
before you reassemble the ITB ( x2,
 x1).
• Make sure that the belt flange [F]
does not touch the roller edge.
B132/B200
[D]
3-76
[B]
[C]
B132R314.WMF
[F]
B132R317A.WMF
SM