Ricoh B132 Service Manual page 524

SERVICE PROGRAM TABLES
2302 Temp/Humid Disp
This SP displays the current temperature and humidity. These readings are output
by the temperature humidity display located on the bottom of the machine below the
waste toner bottle.
001 Temp Disp
002 Rel Humidity Disp
003 Abs Humidity Disp
004 Current Env Disp
2303 Force Temp Corr
The temperature/humidity sensor reading is used to adjust settings during process
control when this SP is set to zero (the default). The value of the absolute humidity
reading displayed by SP2302 003, as well as the other readings of the conditions
around the machine displayed with SP2302, are used in the process control
calculations. If you touch any key (1 to 5) below, the value you select is used and the
readings of the temperature/humidity sensor are ignored.
Note: After you press any key (1 to 5), the setting you select remains in effect only
while the machine is in the SP mode. Once you leave the SP mode, this SP is reset
to zero automatically.
0 Sensor Detect
1 LL
2 ML
3 MM
4 MH
5 HH
2304 Set Humid Thresh
Sets the threshold values for the absolute humidity of the current LL and ML settings
for the main machine in the present environment.
001 Abs Humid:Thresh1
002 Abs Humid:Thresh2
003 Abs Humid:Thresh3
004 Abs Humid:Thresh4
2306 Vd Link Corr
No information is available at this time.
001 Set
002 Correction Coeff
B132/B200
Temperature/Humidity Display
o
Room temperature (
[0~100/1 deg.]
Relative humidity (saturation point at current temperature).
[0~100/1 %rh.]
Absolute humidity.
2
[0~1000/m ]
Displays the current environment control mode. The
control modes are divided into 5 levels: LL, ML, MM, MH,
HH. These levels are determined by thresholds
determined for the other readings of this SP and the
reading of the absolute humidity (SP2301 003).
Force Ambient Temperature Correction DFU
Ambient HumidityThreshold Setting
[0~1000/gm²]
[0~1000/gm²]
[0~1000/gm²]
[0~1000/gm²]
Vd Link Correction
[0~1/1] 0:Off, 1: On
[1~250/100]
5-46
C).
SM