Ricoh B132 Service Manual page 227

[C]
To reinstall the hopper:
1. Confirm that the transfer belt release lever [A] is up and locked before you
reattach the hopper.
2. Make sure the hopper rails are fully extended, then set the toner hopper [B] on
the rails,
3. Make sure the steel tabs of the hopper are inserted into the holes on the left rail
[C] and right rail [D].
4. Push up the release [E] and support leg [F].
Important: Make sure that the support leg is up and locked before you push
the toner hopper into the machine.
5. Place your hands at the bottom of the toner hopper at
the hopper into the machine against the face plate.
Important: To avoid damaging the hopper, never press in on the top of the
toner hopper.
6. Make sure that the hopper is flat against the face plate on the right side.
NOTE: If the toner hopper [B] is not flat against the face plate on the right side,
pull it out slightly and make sure that the transfer belt release lever is
rotated up completely and locked.
7. Fasten the toner hopper to the face plate ( x3).
SM
COMMON REMOVAL PROCEDURES
[D]
[A]
"
[E]
[E]
3-17
[B]
#
B132R908.WMF
" #
and and then push
B132/B200