3.2.7 TONER HOPPER, FACEPLATE, PCU
Removing Hopper, Faceplate, PCU
Important: To avoid damaging the toner end sensor, make sure that the main
power switch is turned off and that the power cord is disconnected from the power
source before you remove the hopper.
To remove the hopper:
1. Prepare an open space on the floor for the hopper.
2. Remove the screws of the toner hopper [A] ( x3).
3. Place your hands under the left and right corners of the toner hopper and
slowly pull it out on its rails until it stops.
I
: T
MPORTANT
HE HOPPER CAN EASILY SLIP OFF ITS RAILS
4. Press the release [B] to drop the support leg [C].
5. Confirm that the support leg is down and locked.
I
: A
MPORTANT
LWAYS MAKE SURE THAT THE SUPPORT LEG IS DOWN AND LOCKED
BEFORE YOU REMOVE THE HOPPER
6. Lift the toner hopper off its rails and set it on the floor.
CAUTION
The hopper is heavy! Lift it carefully, make sure that it disengages
completely from the rails on the left and right, and then set it on
the floor.
7. Push the hopper rails into the machine.
SM
COMMON REMOVAL PROCEDURES
[A]
[C]
.
.
3-11
[B]
B132I006A.WMF
B132/B200