Stc (Soft Toner Cartridge) Installation - Ricoh B132 Service Manual

STC (Soft Toner Cartridge) Installation

Important:
• Make sure that you install each STC in the correct bin.
• The label on the toner cartridge must face the front of the machine.
• From left to right, the bins are for Yellow→ Cyan→ Magenta→ Black.
• The name of the color for each bin is on the decals that are attached to the bin
release levers.
1
B132I107.WMF
1. Push down the lock lever
left) to release it. Then pull the bin
Important: To prevent damage to the bin door, do not try to pull a bin directly
out. Push down on its top edge first to release it, then pull it to open it.
2. Remove the Yellow STC (Soft Toner Cartridge) from its box.
3. Shake the STC [A] up and down about 10 times. Do not squeeze or knead the
toner cartridge (this will make clumps in the toner).
NOTE: The bottom of the cartridge [C] must face down.
4. Set the Yellow STC in the bin [B].
NOTE: Make sure that the color ID label [C] and ID chip terminals [D] are
facing toward you.
5. Push the Yellow STC bin to close and lock it.
6. Do Steps 1 to 6 for the other three STCs (C, M, K)
Important: Make sure that the color of each STC agrees with the label on the
bin door before you install it.
SM
2
'
on the top edge of the Yellow bin (the bin at the far
( in the direction of the front to open it.
1-27
COPIER B132/B200
[C]
[A]
[D]
[B]
B132I108.WMF
B132/B200