Ricoh B132 Service Manual page 616

SERVICE PROGRAM TABLES
6115 Max Prestack
This SP sets the number of sheets sent to the pre-stack tray. With this SP set to the
default (3):
•
3 sheets are sent to the pre-stack tray.
• When the 4th sheet feeds, the 4th sheet and 3 sheets from the pre-stack tray
are sent to the stapling tray together.
Note: You may need to adjust this setting or switch it off when feeding thick or slick
paper.
0:None-3:3Shts
6116 Thk Sht Count
This SP sets the number of sheets of normal thickness to count for one thick sheet.
The default (3) counts three sheets of normal thickness for one thick sheet.
[1~3/1]
6117 Allow Tnk Punch
This SP allows you to switch on punching of OHP sheets. Normally, OHP sheets
cannot be punched. If this SP is switched on (1), the performance of the finisher cannot
be guaranteed (the sheets may jam).
[0~1/1]
6118 Output Jog On
This SP switches the jogging operation of the output jogger attached to the side of the
finisher off and on.
[0~1/1] 0: Off, 1: On
Note: After installation of the Output Jogger Unit B703, this SP must be set to "1" for
the jogging motor to operate the jogging fences.
6119 No Z-Fold/Punch
Switch Z-folding off and on. Default: 0 (Off)
0:No 1:Yes
6120 Free Run
These SPs set the peripherals list below in the free run mode for testing.
001 Free Run 1
002 Free Run 1
003 Free Run 3
004 Free Run 4
B132/B200
Number of Pre-Stack Sheets
[0~3/1 sheet]
0: None
1: 1 sheet
2: 2 sheets
3: 3 sheets
Thick Sheet Count
Allow Punching of OHP Sheets
Output Jogger Operation Off/On
Prohibit Z-Folding and Punching Japan Only
Free Run 1: Post Processing
System Free Run
Free Run (Endurance Testing)
Free Run
Shift, Free Run
5-138
Finishers B701/B700, B706
Finisher B706
Finishers B760, B468/B469
Finisher B706
SM