Assigning The Initial Router Ip Address - Avaya P333R-LB Quick Start Installation Manual

6. At the prompt, type reset. Type y and press Enter to reset the stack. After the Reset, log
in again as described above.
- At the prompt, type set ip route <dest> <gateway> and replace <dest> and
<gateway> with the destination and gateway IP addresses.

Assigning the Initial Router IP Address

Tip:
Commands are shown as follows: set interface inband;parameters which
Tip:
you need to provide are shown in as follows: <vlan>
Note:
The default mode for the Avaya P333R-LB is router mode.
Note:
Note:
Assign the stack IP address as described in
Note:
Address
1. Type session <module number> router where <module number> is the location
of the P333RR-LB in the stack and press Enter.
- The Router-N# prompt appears.
- N is the number of the router in the stack.
2. Type show device-mode and press Enter to ensure that the module is in router mode.
3. Type configure and press Enter.
- The Router-N (configure)# prompt appears.
4. If the IP interface is not on VLAN 1 then continue to step 5, otherwise skip to step 6.
5. Create the management/routing VLAN by typing set vlan <Vlan-ID> name
<Vlan-name>, replacing <VLAN-ID> by the VLAN number; and <Vlan-name> by the
VLAN name and press Enter.
6. Create an IP interface name by typing interface <interface name> and pressing
Enter.
- The Router (configure-if:<interface-name>)# prompt appears
7. Assign the IP address of the interface name you have created by typing ip address
<ip-address> <netmask> and pressing Enter.
8. Assign the VLAN created in step 4 to the IP interface by typing ip vlan <Vlan-id> or
ip vlan name <Vlan-name> and pressing Enter.
9. Type exit and press Enter.
on page 25 before you assign the Initial Router IP Address.
Assigning the Initial Router IP Address
Assigning the Initial Router IP
Issue 1 September 2005 25