Setting Port Speed - Avaya 3500 series Getting Started

Managing Ethernet ports using ACLI

Setting port speed

Set the speed of a port. Ports can be set to a speed of 10 Mb/s, 100 Mb/s, 1000 Mb/s (or 1
GB/s), or auto-negotiated.
Procedure
1. Log on to ACLI in Interface Configuration command mode.
2. At the command prompt, enter the following command:
Variable definitions
The following table describes the parameters for the speed [port <portlist>]
command.
default
port <portlist>
10|100|1000|auto
72 Getting Started
[default] speed [port <portlist>] {10|100|1000|auto}
Variable
Comments? infodev@avaya.com
Value
Sets the speed of the port to the factory
default speed.
Specifies the port numbers to configure the
speed. Enter the port numbers to be
configured.
Important:
If you omit this parameter, the system
uses the port number you specified in the
interface command.
Sets speed to:
• 10 — 10 Mb/s
• 100 — 100 Mb/s
• 1000 — 1000 Mb/s or 1 GB/s
• auto — autonegotiation
Important:
When you set the port speed for
autonegotiation, ensure that the other side
of the link is also set for autonegotiation.
March 2013