Card Cage And Power Supply; Figure 8-29 Disconnecting The Wiring Harnesses And Removing The Card Cage - Tektronix Phaser 440 Service Manual

8
FRU Disassembly/Assembly

Card cage and power supply

8-36 Phaser 440 Color Printer
Tools required
#1 POSIDRIV® screwdriver
1. Power down the printer and remove the power cord. Disconnect all
host interface connectors.
2.
Remove the rear and side cabinet panels. Refer to the earlier topic
"Printer cabinet panels" on page 8-4.
3. Remove the hinged card cage top (held in place by three screws).
4. Disconnect all wiring harnesses from the card cage.
5.
Disconnect the four screws securing the card cage to the print engine
frame (two screws each on the left and the right sides).
4
5

Figure 8-29 Disconnecting the wiring harnesses and removing the card cage

3
Card cage
5
9015-21