Adjusting The Tear-Off Position - IBM 102 User Manual

Adjusting the Tear-off Position

The Dual Purpose Forms Device Document on Demand features
allow you to tear off a form using the tear bar upon completing a
print job. You can then prepare the printer to print the next print job.
Te a r B a r
To change the tear-off position of a form, follow these steps:
1. Make sure the printer is at the top of form position. Press
Load/Eject once.
The printer displays
3 FORMS EJECTED
PRESS LOAD
and the Ready indicator goes off. The paper quickly advances
to the tear-off position.
If you have Models 4I3 and 5I3, you can also use the Automatic
|
Eject or Automatic Restore options to change the tear-off
|
position of a form. See IBM 4230 Printer Models 102, 1I1, 202,
|
2I1, 4I3, and 5I3 Operator Panel Instructions for more
|
information on these options.
|
2. Open the acoustic cover.
3. If the perforation on the form is not at the tear-off position, use
the Micro , Micro , and Line Feed keys to adjust the form
position until the perforation is exactly in line with the tear-off bar.
Chapter 1. Setting Up the 4230 Printer
1-79