D-Link xStackTM DGS-3300 User Manual page 316

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
DGS-3324SRi:4# show pim ipmroute
Command: show pim ipmroute
PIM IP Multicast Route Table
UA = Upstream AssertTimer
AM = Assert Metric
AMPref = Assert MetricPref
ARB
Group Address Source Address
------------------
224.0.1.1
224.0.1.24
224.0.1.24
224.0.1.24
229.55.150.208 10.6.51.1/32
229.55.150.208 10.38.45.151/32
229.55.150.208 10.38.45.192/32
229.55.150.208 10.50.93.100/32
229.55.150.208 10.51.16.1/32
229.55.150.208 10.59.23.10/32
229.55.150.208 31.43.51.81/32
239.192.0.1
Total Entries: 12
DGS-3324SRi:4#
create pim register_checksum_include_data
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To create an RP to which the Switch will send Register packets to and create checksums to be included with the data in
Registered packets:
= Assert RPTBit
------------------
31.43.51.81/32
10.54.81.250/32
10.55.68.64/32
31.43.51.81/32
31.43.51.81/32
Used to set the RPs that the Switch will send Register packets to
and create checksums to be included with the data in Registered
packets.
create pim register_checksum_include_data rp_ address
<ipaddr>
This command will set the RPs that the Switchwill send Register
packets to and create checksums to be included with the data in
Registered packets. This command is for PIM-SM configurations
only.
rp_address <ipaddr> - Enter the IP address of the RP that will verify
checksums included with Registered packets.
Only administrator-level users can use this command.
UA AM AMPref ARB
------ ------ ------ ------
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
313
Flag Type
---- -------
rpt (*.G)
spt (S.G)
spt (S.G)
rpt (*.G)
spt (S.G)
spt (S.G)
spt (S.G)
spt (S.G)
spt (S.G)
spt (S.G)
rpt (*.G)
rpt (*.G)