D-Link xStackTM DGS-3300 User Manual page 210

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
show auth_session_statistics
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current authentication session statistics for port 16:
DGS-3324SRi:4#show auth_diagnostics ports 1:16
Command: show auth_diagnostics ports 1:16
Port number : 1:16
EntersConnecting
EapLogoffsWhileConnecting
EntersAuthenticating
SuccessWhileAuthenticating
TimeoutsWhileAuthenticating
FailWhileAuthenticating
ReauthsWhileAuthenticating
EapStartsWhileAuthenticating
EapLogoffWhileAuthenticating
ReauthsWhileAuthenticated
EapStartsWhileAuthenticated
EapLogoffWhileAuthenticated
BackendResponses
BackendAccessChallenges
BackendOtherRequestsToSupplicant
BackendNonNakResponsesFromSupplicant
BackendAuthSuccesses
BackendAuthFails
CTRL+C ESC q Quit SPACE n
Used to display the current authentication session statistics.
show auth_session_statistics {ports [<portlist> | all]}
The show auth_session statistics command is used to display the
current authentication session statistics of the Switch on a per port
basis.
ports <portlist> − Specifies a range of ports. The port list is specified
by listing the lowest switch number and the beginning port number on
that switch, separated by a colon. Then the highest switch number,
and the highest port number of the range (also separated by a colon)
are specified. The beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies switch number 1,
port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of
the ports between switch 1, port 3 and switch 2, port 4 − in numerical
order.
all – Specifies that all ports will be viewed.
None.
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
Next Page Enter Next Entry
207
a All