D-Link xStackTM DGS-3300 User Manual page 36

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
Command
delete snmp host
show snmp host
create trusted_host
delete trusted_host
show trusted_host
enable snmp traps
enable snmp
authenticate_traps
show snmp traps
disable snmp traps
disable snmp
authenticate_traps
config snmp system
contact
config snmp system
location
config snmp system
name
enable rmon
disable rmon
Each command is listed, in detail, in the following sections.
create snmp user
Purpose
Syntax
Description
Parameters
<ipaddr>
<ipaddr>
<ipaddr>
<ipaddr>
<ipaddr>
<sw_contact>
<sw_location>
<sw_name>
Used to create a new SNMP user and adds the user to an SNMP group
that is also created by this command.
create snmp user <SNMP_name 32> <groupname 32> {encrypted
[by_password auth [md5 <auth_password 8-16> | sha
<auth_password 8-20>] priv [none | des <priv_password 8-16>] |
by_key auth [md5 <auth_key 32-32> | sha <auth_key 40-40>] priv
[none | des <priv_key 32-32>]]}
The create snmp user command creates a new SNMP user and adds
the user to an SNMP group that is also created by this command. SNMP
ensures:
Message integrity − Ensures that packets have not been tampered with
during transit.
Authentication − Determines if an SNMP message is from a valid source.
Encryption − Scrambles the contents of messages to prevent it from
being viewed by an unauthorized source.
33