D-Link xStackTM DGS-3300 User Manual page 5

Xstack dgs/dxs-3300 series layer 3 stackable gigabit ethernet switch
Table of Contents

Advertisement

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
There is no initial username or password. Just press the Enter key twice to display the CLI input cursor − DGS-3324SRi:4#.
This is the command line where all commands are input.
Setting the Switch's IP Address
Each switch must be assigned its own IP Address, which is used for communication with an SNMP network manager or other
TCP/IP application (for example BOOTP, TFTP). The Switch's default IP address is 10.90.90.90. The default switch IP address
can be changed to meet the specification of your networking address scheme.
The Switch is also assigned a unique MAC address by the factory. This MAC address cannot be changed, and can be found on
the initial boot console screen – shown below.
The Switch's MAC address can also be found in the Web management program on the Switch Information (Basic Settings)
window on the Configuration menu.
The IP address for the Switch must be set before it can be managed with the Web-based manager. The Switch IP address can be
automatically set using BOOTP or DHCP protocols, in which case the actual address assigned to the Switch must be known.
The IP address may be set using the Command Line Interface (CLI) over the console serial port as follows:
1. Starting
at
the
xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy. Where the x's represent the IP address to be assigned to the IP interface named
System and the y's represent the corresponding subnet mask.
2. Alternatively, the user may enter config ipif System ipaddress xxx.xxx.xxx.xxx/z. Where the x's represent the IP
address to be assigned to the IP interface named System and the z represents the corresponding number of subnets in
CIDR notation.
The IP interface named System on the Switch can be assigned an IP address and subnet mask which can then be used to connect
a management station to the Switch's Telnet or Web-based management agent.
Figure 1-2. Boot Screen
command
line
prompt,
enter
the
commands
2
config
ipif
System
ipaddress

Advertisement

Table of Contents
loading

Table of Contents