D-Link xStackTM DGS-3300 User Manual page 260

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
disable sntp
Purpose
Syntax
Description
Parameters
Restrictions
Example:
To stop SNTP support:
DGS-3324SRi:4#disable sntp
Command: disable sntp
Success.
DGS-3324SRi:4#
config sntp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure SNTP settings:
Disables SNTP server support.
disable sntp
This will disable SNTP support. SNTP service must be separately
configured (see config sntp).
None.
Only administrator-level users can issue this command.
Used to setup SNTP service.
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-
interval <int 30-99999>}
Use this command to configure SNTP service from a NTP server.
SNTP must be enabled for this command to function (See enable
sntp).
primary − This is the primary server the SNTP information will be
taken from.
<ipaddr> − The IP address of the primary server.
secondary − This is the secondary server the SNTP information
will be taken from in the event the primary server is unavailable.
<ipaddr> − The IP address for the secondary server.
poll-interval <int 30-99999> − This is the interval between
requests for updated SNTP information. The polling interval
ranges from 30 to 99,999 seconds.
Only administrator-level users can issue this command. SNTP
service must be enabled for this command to function (enable
sntp).
257