D-Link xStackTM DGS-3300 User Manual page 336

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
show ospf virtual_neighbor
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example
To display the current OSPF virtual neighbor table:
DGS-3324SRi:4#show ospf virtual_neighbor
Command: show ospf virtual_neighbor
Transit
Area ID
------------
10.1.1.1
Total Entries : 1
DGS-3324SRi:4#
config ospf ipif
Purpose
Syntax
Description
Used to display the current OSPF virtual neighbor router table.
show ospf virtual_neighbor {<area_id> <neighbor id>}
This command will display the current OSPF virtual neighbor
router table.
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<neighbor_id> − The OSPF router ID for the neighbor. This is a
32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that
uniquely identifies the remote area's Area Border Router.
None.
Router ID of IP Address of
Virtual Neighbor Virtual Neighbor State
---------------- ---------------
10.2.3.4 10.48.74.111
Used to configure the OSPF interface settings.
config ospf ipif <ipif_name 12> {area <area_id> | priority
<value> | hello_interval <sec 1-65535>| dead_interval <sec 1-
65535> | authentication [none | simple <password 8> | md5
<key_id 1-255>] | metric <value 1-65535> | state [enable |
disable]}
This command is used to configure the OSPF interface settings.
Virtual Neighbor
----------------
Exchange
333