D-Link xStackTM DGS-3300 User Manual page 183

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
config ssh user
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the SSH user:
DGS-3324SRi:4# config ssh user Trinity authmode password
Command: config ssh user Trinity authmode password
Success.
DGS-3324SRi:4#
DGS-3324SRi:4# show ssh server
Command: show ssh server
SSH Server Status
SSH Max Session
Connection timeout
Authenticate failed attempts
Rekey timeout
Listened Port Number
DGS-3324SRi:4#
Used to configure the SSH user.
config ssh user <username 15> authmode {hostbased
[hostname <string 32> | hostname_IP <string 32> <ipaddr>} |
password | publickey]
This command allows users to configure the SSH user
authentication method.
<username 15> - Enter a username of no more than 15 characters
to identify the SSH user.
authmode – Specifies the authentication mode of the SSH user
attempting to log on to the Switch. The administrator may choose
between:
hostbased – This parameter should be chosen if the user
wishes to use a remote SSH server for authentication purposes.
Choosing this parameter requires the user to input the following
information to identify the SSH user.
hostname <string 32> - Enter an alphanumeric string of up
to 31 characters identifying the remote SSH user.
hostname_IP <string 32> <ipaddr> - Enter the hostname
and the corresponding IP address of the SSH user.
password – This parameter should be chosen if the user
wishes to use an administrator defined password for
authentication. Upon entry of this command, the Switch will
prompt the user for a password, and then to retype the
password for confirmation.
publickey – This parameter should be chosen if the user
wishes to use the publickey on a SSH server for authentication.
Only administrator-level users can issue this command.
: Disabled
: 3
: 120 (sec)
: 2
: Never
: 22
180