D-Link xStackTM DGS-3300 User Manual page 333

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
delete ospf aggregation
Parameters
Restrictions
Usage Example
To configure the OSPF area aggregation settings:
DGS-3324SRi:4#delete ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type summary
Command: delete ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type summary
Success.
DGS-3324SRi:4#
config ospf aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example
To configure the OSPF area aggregation settings:
DGS-3324SRi:4#config ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type
summary advertise enable
Command: config ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type
summary advertise enable
Success.
DGS-3324SRi:4#
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<network_address> − The 32-bit number in the form of an IP
address that uniquely identifies the network that corresponds to
the OSPF Area.
lsdb_type summary − Specifies the type of address aggregation.
Only administrator-level users can issue this command.
Used to configure the OSPF area aggregation settings.
config ospf aggregation <area_id> <network_address>
lsdb_type summary {advertise [enable | disable]}
This command is used to configure the OSPF area aggregation
settings.
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<network_address> − The 32-bit number in the form of an IP
address that uniquely identifies the network that corresponds to
the OSPF Area.
lsdb_type summary − Specifies the type of address aggregation.
advertise [enable | disable] − Allows for the advertisement trigger
to be enabled or disabled.
Only administrator-level users can issue this command.
330