D-Link xStackTM DGS-3300 User Manual page 58

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
upload
Restrictions
Example usage:
To upload a configuration file:
DGS-3324SRi:4#upload cfg_toTFTP 10.48.74.121 c:\cfg\log.txt
Command: upload cfg_toTFTP 10.48.74.121 c:\cfg\log.txt
Connecting to server................... Done.
Upload configuration...................Done.
DGS-3324SRi:4#
config firmware
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete a firmware from the Switch's memory:
Example usage:
To configure a firmware as the boot up runtime image firmware:
The TFTP server must be on the same IP subnet as the Switch.
Only administrator-level users can issue this command.
To configure firmware currently in the Switch's NV-RAM.
config firmware image_id <int 1-2> {delete | boot_up]
This command allows the user to configure the dual image firmware
on the Switch. This Switch allows the user to hold two firmware
versions in its memory, labeled as image_id 1 and 2. Using this
command, the user may delete a firmware or set it as the boot up
firmware for the Switch. If the boot up firmware is not specified by
the user, image_id 1 will be the default boot up firmware.
<int 1-2> - Select the ID number of the firmware in the Switch's
memory to be configured.
delete – Selecting this parameter, along with the image_id will delete
this firmware from the Switch's memory.
boot_up - Selecting this parameter, along with the image_id will set
this firmware as the default boot up runtime image firmware upon the
next reboot of the Switch.
Only administrator-level users can issue this command.
DGS-3324SRi:4#config firmware image_id 2 delete
Command: config firmware image_id 2 delete
Success.
DGS-3324SRi:4#
55