D-Link xStackTM DGS-3300 User Manual page 132

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
show lacp_port
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display LACP port mode settings:
DGS-3324SRi:4#show lacp_port 1:1-1:8
Command: show lacp_port 1:1-1:8
Port
------
1:1
1:2
1:3
1:4
1:5
1:6
1:7
1:8
DGS-3324SRi:4#
Used to display current LACP port mode settings.
show lacp_port {<portlist>}
This command will display the LACP mode settings as they are
currently configured.
<portlist> - Specifies a range of ports that will be viewed. The port
list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end of
the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2,
port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and
switch 2, port 4 − in numerical order.
Only administrator-level users can issue this command.
Activity
--------
Active
Active
Active
Active
Active
Active
Active
Active
129