D-Link xStackTM DGS-3300 User Manual page 303

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
Command
config pim crp
create pim static_rp group
delete pim static_rp group
show pim static_rp
config pim rp_spt_threshold
config pim last_hop_spt_threshold
show pim rpset
show pim crp
config pim cbsr
show pim cbsr
show pim
show pim neighbor
show pim ipmroute
create pim
register_checksum_include_data
rp_address
delete pim
register_checksum_include_data
rp_address
show pim
register_checksum_include_data_rp_list
Each command is listed, in detail, in the following sections.
enable pim
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To enable PIM as previously configured on the Switch:
DGS-3324SRi:4#enable pim
Command: enable pim
Success.
Parameters
{holdtime <value 0-255> | priority <value 0-255>
| wildcard_prefix_cnt [0 | 1]}
<network address> rp <ipaddr>
<network address>
[<value 0-65535> | infinity]
[<value 0-65535> | infinity]
[ipif <ipif_name 12> {priority [-1 | <value 0-
255>]} | hash_masklen <value 0-32> |
bootstrap_period <value 1-255>]
{ipif <ipif_name 12>}
{ipif <ipif_name 12>}
{ipif <ipif_name 12> | ipaddress
<network_address>}
<ipaddr>
<ipaddr>
Used to enable the PIM function on the Switch.
enable pim
This command will enable PIM for the Switch. PIM settings must first
be configured for specific IP interfaces using the config pim
command.
None.
Only administrator-level users can use this command.
300